Exfo FTB-8500 Series for FTB-200 Instrukcja Użytkownika Pobierz pdf (Strona 317)

100

101

EtherSAM Tabs

Ethernet and Fibre Channel Application 303

Configuration Test (Results)

Ramp and Burst Tests Table

 Step, for ramp test, indicates the ramp step number or name.

 CIR %, for ramp test, indicates the percentage of CIR used for each

step (see SLA Parameters on page 287).

 Burst Test: indicates the two burst tests: CBS and EBS.

 Burst Size indicates the size of the burst used for the test (see SLA

Parameters on page 287).

 Direction: Direction is displayed for dual test set test case providing

bidirectional data.

L -> R indicates results from local to remote direction.

R -> L indicates results from remote to local direction.

 Frame Loss (%) indicates the percentage of frames that are lost. Note

that the reported value is the maximum percentage of Frame Loss

from all the burst sequences and ramp steps excluding the CIR+EIR,

EBS, and Traffic Policing steps.

 Max Jitter (ms) indicates the maximum measured delay variation.

 Max Round-Trip Latency (ms) indicates the maximum measured

round trip latency (delay). For FTB-8120NGE and FTB-8130NGE in Dual

Test Set, only available with round-trip latency measurement mode.

 Max Latency (ms) indicates the maximum measured one way latency

(delay). Only available with FTB-8120NGE and FTB-8130NGE in Dual

Test Set one-way latency measurement mode. Not Measurable is

displayed when the maximum latency is higher than 500 ms.

1 2 ... 312 313 314 315 316 317 318 319 320 321 322 ... 512 513

Komentarze do niniejszej Instrukcji

Brak uwag

Exfo FTB-8500 Series for FTB-200 Instrukcja Użytkownika Strona 317

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Urządzenia pomiarowe Exfo FTB-8500 Series for FTB-200