Exfo FOT-930 Multifunction Loss Tester Instrukcja Użytkownika Pobierz pdf (Strona 27)

Customizing Your Multifunction Loss Tester

Multifunction Loss Tester 19

Adjusting the Brightness and Contrast

To fit your work environment, you may adjust the LCD brightness and

contrast. Values are kept in memory when you turn the unit off. You may

also revert to factory settings at any time.

Note: These settings do not apply to the Fiber Inspection Probe display. For

details, see Inspecting Fibers with the FIP on page 63.

To adjust the display brightness and contrast:

Press the key repeatedly to switch between brightness levels (0-4-7-10).

1. Press Menu, then select Setup > Unit.

2. Press Next Tab (F1/F2 key) until you get to

the LCD tab.

3. Use the up/down arrows to select the

Brightness or Contrast slider.

4. Use the left/right arrows to adjust the

brightness or contrast level.

To revert unit to factory-default settings:

1. Press Menu, then select Setup > Unit.

2. Press Factory Settings (F1/F2 key). Values on all tabs of the Unit Setup

pane are returned to factory settings.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 110 111

Brak uwag

Exfo FOT-930 Multifunction Loss Tester Instrukcja Użytkownika Strona 27