Exfo AXS-200 SharpTESTER Instrukcja Użytkownika Strona 44

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
Przeglądanie stron 43
Maintenance
36 AXS-200
Changing the Module Backplane
Changing the Module Backplane
It is possible for you to change the backplane of the unit (swap modules).
This implies however that you must reinstall the software corresponding to
your new module, otherwise you will have a Software Mismatch message,
as seen in Software Mismatch Notification on page 38.
To change the module backplane:
1. Turn the unit off (shutdown mode). Make sure that the unit is not in
suspend mode.
2. Open the battery compartment.
3. Loosen the module retaining screw located at the bottom of the
battery compartment. This is a captive screw; you cannot remove it
completely.
Module retaining screw
Przeglądanie stron 43
1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 69 70

Komentarze do niniejszej Instrukcji

Brak uwag